1. Adjustment of double headed saw for broken bridge aluminum door and window processing equipment and door and window equipment.

(1) Adjust the position of the compression cylinder

Place the aluminum alloy profile on the workbench of the aluminum door and window equipment, adjust the clamping cylinder of the two saw heads to the appropriate position for clamping the workpiece, and then fix the clamping cylinder.

(2) Adjust the feed speed of the saw blade

First, test the machine with the default feed rate of the cutting saw blade at the factory. During the test, if you feel that the feed rate of the saw blade is not suitable, you can adjust the working cylinder speed control joint to increase or decrease the feed rate to obtain the desired feed rate.

(3) Adjust the sawing angle

After adjusting the precision cutting saw for aluminum alloy profiles according to the above requirements and checking for compliance with regulations, a trial run of 30 minutes is required.

(4) Adjust the cutting angle of the equipment to 90 ° (with the saw blade extending perpendicular to the workbench)

Before leaving the factory, precision cutting saws for aluminum alloy profiles are debugged and inspected to be qualified. Here, an aluminum alloy profile can be directly sawed, and the 90 degree angle of the saw surface can be inspected to ensure that it meets the requirements, with an error of ± 10 '. If it does not meet the requirements, the bolts on the limit block can be adjusted. Then repeat the sawing measurement to meet the requirements. Pay attention to locking the nut on the cutting saw afterwards.